Mar 07, 2024 Leave a message

Low temperature electrofusion straight seam welded pipe

Low-temperature electrofusion straight seam welded pipe refers to a welded steel pipe whose steel grade is a low-temperature resistant steel plate, and the weld seam produced by the electrofusion welding method is a straight bar shape. Low-temperature electrofusion straight seam welded pipes mainly use steel grades of 16MnDR, 15MnNiDR, 15MnNbDR, 09MnNiDR, 08Ni3DR, and 09Ni9DR low-temperature resistant steel as raw materials for production.
Electrofusion welding refers to a welding process that uses arc heating and filler materials to achieve interatomic bonding of the metal to be welded to form a permanent joint. It mainly includes submerged arc welding (SAW), electrode arc welding (SMAW), and molten arc welding. Shielded welding (GMAW and FCAW), gas tungsten arc welding with filler metal (GTAW), and process combinations between them.
Recommended heat treatment system for low-temperature electrofusion straight seam welded pipes: 1. When the steel grade is 16MnDR, the stress relief heat treatment temperature range is 600-650 degrees Celsius (wall thickness > 25mm). Steel pipes with wall thickness ≤ 25mm do not need to be heat treated. 2. When the steel grade is 15MnNiDR, the stress relief heat treatment temperature range is 600-650 degrees Celsius (wall thickness > 20mm). Steel pipes with wall thickness ≤ 20mm do not need to be heat treated. 3. When the steel grade is 15MnNbDR, the stress relief heat treatment temperature range is 600-650 degrees Celsius. 4. Steel grade 09MnNiDR, stress relief heat treatment temperature range is 600-650 degrees Celsius. 5. When the steel grade is 08Ni3DR, the stress relief heat treatment temperature range is 600-650 degrees Celsius. The minimum insulation time determined by thickness: when the thickness is less than 50mm, it is 2.4 minutes per mm; when the thickness is not less than 50mm, the insulation time is 2 hours; when the thickness is increased by 25mm, the insulation time increases by 15 minutes. Low-temperature electrofusion straight seam welded pipes should be subjected to hydraulic pressure tests one by one. The test pressure should be calculated according to the formula P=2ST/D, P=hydraulic test pressure, in megapascals (Mpa); S=hydraulic test hoop stress, The unit is MPa (Mpa), and its value is selected from 80% of the minimum yield strength of the steel plate; T = nominal wall thickness, in millimeters (mm); D = nominal outer diameter, in millimeters (mm).

Low temperature electrofusion straight seam welded pipe

Send Inquiry

whatsapp

Phone

E-mail

Inquiry