SSAW vs LSAW Pipe: What Is the Difference?
In high-capacity energy transmission and infrastructure, two technologies dominate the large-diameter steel pipe market: SSAW (Spiral Submerged Arc Welded) and LSAW (Longitudinal Submerged Arc Welded). Both use submerged arc welding, where the arc burns under a layer of flux to produce high-purity, deep-penetration joints, but their forming methods offer different technical and economic advantages.
1. Manufacturing and Forming Mechanisms
LSAW:
produced by cold-forming a single steel plate (JCOE/UOE processes), creating one straight longitudinal weld seam.
SSAW:
manufactured by continuously angling and rolling steel coil into a cylinder, creating a continuous spiral weld seam.
2. Weld Integrity and Stress Profiles
LSAW:
precision forming and expansion give uniform wall thickness and high roundness; the straight seam is easy to inspect with 100% NDT.
SSAW:
the spiral seam acts as a structural rib, distributing internal and external stresses more evenly - valuable for external soil loads in piling and water transmission.
3. Dimensional Range and Capability
| Feature | SSAW (Spiral) | LSAW (Longitudinal) |
|---|---|---|
| Input material | Steel strip (coils) | Steel plate |
| Seam form | Spiral (longer) | Straight (shorter) |
| Geometric accuracy | Standard (good) | High (precision expansion) |
| Investment cost | Lower | Higher |
| Main use case | Water, piling, distribution | Gas trunk lines, subsea |
Economic and Project Considerations
SSAW requires lower capital investment and operating costs, giving a price advantage for medium-to-large diameter low-pressure water mains and structural piles. LSAW, though more expensive per ton, is mandated for critical high-pressure gas mains and deep-sea riser systems where dimensional consistency and weld reliability are primary safety requirements.
Frequently Asked Questions
Is the spiral weld more prone to cracking?
Modern SSAW with rigorous NDT and 100% penetration produces a weld as tough as the base metal, though the longer seam requires more monitoring.
Why use SSAW for large-diameter municipal water?
It is more cost-effective above 24 inches and provides the load-bearing capacity needed for external soil and water pressure.
Can both meet API 5L PSL2?
Yes. Both routes can satisfy the mechanical, toughness and NDT requirements of API 5L PSL2.
What is JCOE in LSAW manufacturing?
Forming steps that stamp the plate into J, C and O shapes, followed by mechanical expansion (E) for roundness.
How are the seams protected from corrosion?
External 3PE or FBE coatings provide a 50+ year moisture barrier for both types.
How is LSAW pipe formed?
LSAW pipe is cold-formed from a single steel plate using the JCOE or UOE process, creating one straight longitudinal weld seam.





