May 07, 2025 Leave a message

Ultrasonic Flaw Detection Procedure For API Steel Pipes

API steel pipe ultrasonic flaw detection steps need to strictly follow the requirements of API SPEC 5L and other standards, combined with manual and automatic inspection techniques, the specific process is as follows:

I. Pre-test preparation
Surface treatment
Clean the inner and outer walls of the steel pipe, thoroughly remove the oxide skin, oil and rust, to ensure effective ultrasonic coupling.
Equipment and parameter setting
According to the specifications of the steel pipe (OD ≥ 6mm, wall thickness / OD ratio of ≤ 0.2) to choose the probe type and frequency, giving priority to the use of transverse wave reflection method.
Configure the coupling agent (e.g. water, glycerol) to ensure effective ultrasonic penetration.
Personnel qualification
Operators should hold ISO 11484 or ASNT SNT-TC-1A certified 1/2/3 qualification, and the method needs to be reassessed within 12 months.
II. Calibration and Comparison Specimens
Comparison Specimen Selection
Use V-groove or flat-bottomed hole specimens, in accordance with API SPEC 5L and SY/T 6423 series standard requirements.
Sensitivity Calibration
Adjust the instrument gain and alarm threshold to ensure that the minimum allowable defect signal can be identified.
3. Inspection Implementation
Longitudinal defect detection
The sound beam propagates in the circumferential direction along the pipe wall, and the probe moves relative to the steel pipe, covering the entire surface.
Automatic detection of the two ends of the blind zone should be controlled within 200mm.
Transverse defect detection
The sound beam propagates along the pipe axis, and sweeps in two opposite directions of the pipe.
Only at the request of the demand-side implementation, can be negotiated in a single direction sweep.
Coupling control
Real-time monitoring of the coupling effect is required for automatic detection, and the coupling agent needs to be replenished periodically for manual detection.

API 5L X42 pipeline
4. Data analysis and defect assessment
Signal interpretation
Reflected wave position to determine the depth of defects, the amplitude to determine the equivalent size.
Penetration method to determine the severity of defects through energy attenuation.
Suspicious area treatment
Repeat the test or use other NDT methods (e.g. magnetic particle testing) to re-test.
Re-test after cutting out the suspicious area, if it still exceeds the standard, it is judged to be unqualified.
5. Record and Certification
Report content
Contains detection parameters, defect location / size, the basis for judgement (such as API SPEC 5L 44 version) and the operator's signature.
API certification requirements
The equipment must be validated to EN 10246-8 or equivalent.
The quality management system needs to cover the elements of the API Q1 specification and pass an internal audit/management review.
Precautions
Manual inspection is permitted for special large diameter tubes, but full surface coverage needs to be ensured.
Automatic inspection system needs to be regularly tested for performance according to YB 4082-92 standard.
Probe parameters need to be adjusted to compensate for temperature effects in high temperature environments (≤70℃).

API 5L GRB pipeline

Send Inquiry

whatsapp

Phone

E-mail

Inquiry